Articles: Cooling

Bookmark and Share

Pages: [ 1 | 2 | 3 | 4 | 5 | 6 | 7 ]

Technical Specifications and Recommended Pricing

Testbed and Testing Methodology

We performed all cooler tests inside a closed system case. Here is our testbed configuration:

We overclocked our six-core processor (with its default non-lapped heat-spreader) with the multiplier set at 25x and “Load-Line Calibration” (Level 2) enabled to 4.3 GHz. The nominal processor Vcore was increased to 1.3875 V in the mainboard BIOS:

Turbo Boost and Hyper-Threading technologies were disabled during our test session. The memory voltage was at 1.5 V and its frequency was 1.38 GHz with 7-7-7-16_1T timings (Extreme profile). All other parameters available in the mainboard BIOS and related to CPU or memory overclocking remained unchanged.

All tests were performed under Windows 7 Ultimate x64 SP1 operating system. We used the following software during our test session:

  • CPU Stress Test (CST) version 0.18b – to load the processor (matrix # 15, 10-12 minutes);
  • Real Temp GT 3.64 – to monitor the processor core temperature;
  • CPU-Tweaker 1.5 – to visually monitor temperatures and frequencies using graphics;
  • Gigabyte Easy Tune 6 B11.0823.1 – to monitor voltages.

So, the complete screenshot during the test session looks as follows:

The CPU was loaded with two consecutive CST test runs with the settings as indicated above. The stabilization period for the CPU temperature between the two test cycles was about 8-10 minutes. We took the maximum temperature of the hottest CPU core for the results charts. Moreover, we will also provide a table with the temperature readings for all cores including their average values. The ambient temperature was checked next to the system case with an electronic thermometer with 0.1 °C precision that allows hourly monitoring of the temperature changes over the past 6 hours. The room temperature during our test session varied between 23.4-23.9 °C.

The noise level of each cooler was measured between 1:00 and 3:00 AM in a closed room about 20 m2 big using CENTER-321 electronic noise meter. The noise level for each cooler was tested outside the system case when the only noise sources in the lab were the cooler and its fan. The noise meter was installed on a tripod and was always at a 150 mm distance from the cooler fan rotor. The tested cooling systems were placed at the edge of the desk on a sheet of polyurethane foam. The lowest noise reading our noise meter device can register is 29.8 dBA and the subjectively comfortable noise level in these testing conditions was around 36 dBA (do not mix it up with low noise level). The fan(s) rotation speed was adjusted in the entire supported range using our in-house controller by changing the voltage with 0.5 V increment.

We are going to compare Antec KÜHLER H2O 920 against Thermalright HR-02 Macho ($40) tested with one default Thermalright TY-140 fan:

This cooler was more than enough to get a good idea of the Antec system’s cooling efficiency.

Now let’s check out the obtained results.

Pages: [ 1 | 2 | 3 | 4 | 5 | 6 | 7 ]


Comments currently: 28
Discussion started: 11/22/11 07:51:03 PM
Latest comment: 12/19/12 09:06:04 AM

View comments

Add your Comment