Testbed and Methods
Our Antec Twelve Hundred system case has a transparent window in the side panel. However, there is a plastic frame for the fan on it, which hit against the front side of CoolIT Domino A.L.C. system when we tried to close the case. That is why we performed all tests in a system case with the removed side panel.
Our testbed was configured as follows:
- Mainboard: ASUS P6T Deluxe (Intel X58 Express), LGA 1366, BIOS 1303;
- Processor: Intel Core i7-920, 2.67GHz, 1.25V, 4 x 256KB L2, 8MB L3 (Bloomfield, C0);
- Thermal interface: Arctic Silver 5;
- Graphics card: ZOTAC GeForce GTX 260 AMP2! Edition 896MB, 648/1404/2108MHz (1030RPM);
- Memory: DDR3 3 x 1GB Corsair DOMINATOR TWIN3X2048-1800C7DFIN (Spec: 1800MHz / 7-7-7-20 / 2.0V);
- Disk subsystem: Western Digital VelociRaptor (SATA-II, 300GB storage capacity, 10,000RPM, 16MB cache, NCQ);
- HDD silencer and cooler: Scythe Quiet Drive 3.5”;
- Optical drive: Samsung SH-S183L;
- System case: Antec Twelve Hundred (default 120mm fans replaced with Scythe Slip Stream 120 fans at 800RPM; 120-mm Scythe Gentle Typhoon at 800RPM installed on the lower front of the case; standard 200-mm fan at 400RPM at the top of the case);
- Control and monitoring panel: Zalman ZM-MFC2;
- Power supply: Zalman ZM1000-HP 1000W (with a default 140 mm fan).
All tests were performed under Windows Vista Ultimate Edition x86 SP1. We used the following software during our test session:
- Real Temp 3.19b – to monitor the processor core temperature;
- Linpack 32-bit with LinX shell version 0.5.8 – to create maximum CPU load (two test cycles, 15 Linpack runs in each cycle with 1624 MB RAM capacity involved);
- RivaTuner 2.24 – to visually control temperature changes (with RTCore plugin).
So, the complete screenshot during the test session looks as follows:
The stabilization period for the CPU temperature between the two test cycles was about 10 minutes. We took the maximum temperature of the hottest processor core of the four for the results charts. The ambient temperature was checked next to the system case or open testbed with an electronic thermometer with 0.1°C precision that allows monitoring the temperature changes over the past 6 hours. During our test session room temperature stayed at 23.5-24°C.
The noise level of each cooler was measured after 1:00AM in a closed room about 20sq.m big using CENTER-321 electronic noise meter. The measurements were taken at 1m and 3m distance from the closed system case. During the acoustics tests all five 120-mm case fans were slowed down to ~520 RPM. In this mode the background noise from the system case measured at 1m distance didn’t exceed ~33.3 dBA. When the system was completely powered off, our noise meter detected 30.8 dBA (the lowest on the charts is 30 dBA). The subjectively comfortable noise level is around 34.5~35 dBA.
Now let me say a few words about the today’s main competitor. It was Thermalright IFX-14 ($79.90), as it is the most efficient air cooler today that is priced exactly as CoolIT Domino A.L.C.
We equipped IFX-14 with one and two SilenX iXtrema Pro IXP-76-14 fans (120 x 120 x 38 mm) working at 930 and 1410 RPM.