Articles: Cooling
 

Bookmark and Share

(2) 
Pages: [ 1 | 2 | 3 | 4 | 5 ]

Technical Specifications and Recommended Pricing

Testbed and Methods

The tests were performed in a closed system case. Our testbed was configured as follows:

I am sure you have already read our recent review of the Gigabyte graphics card equipped with a unique and pretty efficient cooling system:

Deepcool Dracula is going to compete against this particular cooler.

The testing programs were installed under Microsoft Windows 7 Ultimate x64 SP1. We used DirectX End-User Runtimes libraries (from November 2010), Nvidia GeForce/ION 285.27 beta graphics card drivers. We used five runs of Aliens vs. Predator game in 2560x1600 resolution and with maximum image quality settings, 16x anisotropic filtering and 4x antialiasing:

With the settings we used this test loads the powerful graphics accelerator very heavily, but can’t damage it, which could be the case with FurMark (this time we decided not to use this benchmark in our test session).

We used MSI Afterburner utility version 2.2.0 Beta 7 to monitor graphics card temperatures and frequencies and GPU-Z version 0.5.5 utility:

The tests were run at least twice. The temperature stabilization period between the two test cycles was about 10-12 minutes. The ambient temperature was checked next to the system case with an electronic thermometer with 0.1°C precision that allows monitoring the temperature changes over the past 6 hours. During our test session room temperature stayed around 22.4-22.6°C.

We used our in-house controller to adjust the rotation speed of the Deepcool fans.

The noise level of each cooler was measured between 1:00 and 3:00 AM in a closed room about 20 m2 big using CENTER-321 electronic noise meter. The noise level for each cooler was tested outside the system case when the only noise sources in the lab were the cooler and its fan. The noise meter was installed on a tripod and was always at a 150 mm distance from the cooler fan rotor. The tested cooling systems were placed at the edge of the desk on a sheet of polyurethane foam. The lowest noise reading our noise meter device can register is 29.8 dBA and the subjectively comfortable noise level in these testing conditions was around 36 dBA (do not mix it up with low noise level).

 
Pages: [ 1 | 2 | 3 | 4 | 5 ]

Discussion

Comments currently: 2
Discussion started: 10/24/11 11:12:01 PM
Latest comment: 11/16/11 07:24:13 PM

View comments

Add your Comment