Articles: Mainboards
 

Bookmark and Share

(6) 
Pages: [ 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 ]

Power Consumption

We performed our power consumption measurements in nominal and overclocked modes using Extech Power Analyzer 380803. This device is connected before the PSU and measures the power draw of the entire system (without the monitor), including the power loss that occurs in the PSU itself. In the idle mode we start the system up and wait until it stops accessing the hard disk. The results on the diagrams are sorted out in ascending order.

We’ve mentioned the power efficiency of MSI mainboards above, and the idle power consumption diagram is a good illustration of that fact. However, it doesn't show the full picture.

For all their downsides, Haswell-based CPUs should be given credit for requiring less power in idle mode in comparison with their LGA1155 counterparts. Unfortunately, we can’t see that when the mainboards work at their default settings, so we have an additional test mode called Eco. It means the same default settings but we manually switch all options referring to Intel’s power-saving technologies from Auto to Enabled in the mainboards’ BIOSes. This helps improve the results, lowering the power consumption of our configurations considerably, and the MSI Z87-G43 is still the most economical.

We want to remind you that we install an AMD Radeon HD 7970 graphics card into our test configurations. If we instead used the CPU-integrated graphics core, the overall power draw would be lower than 30 watts. Haswell-based CPUs are indeed very economical when idle, so it is a shame that the mainboards do not ensure this advantage by default. You have to correct some BIOS options for that.

The high load on our Haswell is created by the LinX utility with support for AVX instructions. It is heavier on the CPU than ordinary applications, yet it is just an application nonetheless. It is quite possible that there are some other programs that can be just as heavy. That’s why we stick to using LinX for the purpose of checking the computer out for stability and when measuring its power consumption.

The numbers are high, but they are close to the highest power consumption possible at all. To measure the power draw of our configurations in typical applications, we used the Fritz benchmark. It doesn’t really matter which exactly application you use for that purpose. Any ordinary program that can run on all four CPU cores will produce the same or comparable results. So it turns out that we shouldn’t worry about the high power draw under the AVX-using LinX. The typical power consumption is actually lower than 100 watts. The MSI Z87-G43 is still the most economical mainboard in comparison with the other models.

By the way, you have to count in the graphics card’s power draw to calculate the overall system consumption. We use CPU loads in our power consumption tests, but if we load the AMD Radeon HD 7970, the total power draw will be close to 250 watts at default settings and even higher at overclocking.

The mainboards don’t differ much in idle mode when overclocked, yet the MSI is the most economical again.

We don’t have a special Eco mode here because we always use as many power-saving technologies as possible while overclocking. The results are paradoxical even. The overclocked systems (working at increased CPU voltage) need as much power as in the Eco mode above and less than at the default settings. It just proves once again how important it is to enable all power-saving technologies if you want your computer to be energy efficient.

The overclocked systems need much more power at high loads compared to themselves at the default settings. The high frequencies and increased voltages show up then.

So, the MSI Z87-G43 is the most energy-efficient among the tested mainboards at default and overclocked settings. It is good that, despite all the changes, MSI products are as economical as before.

 
Pages: [ 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 ]

Discussion

Comments currently: 6
Discussion started: 10/28/13 01:23:38 AM
Latest comment: 02/09/14 12:21:28 PM

View comments

Add your Comment