Interior Design and Assembly Tips

I unfastened three screws at the back panel and pulled it backward to remove the top cover.

The handle is fastened to the cover by means of a bar that distributes the load along a large area:

This is a proper solution since the system assembled out of full-size components is going to be very heavy.

The chassis elements are packed rather densely inside. There is a 5.25” cage in the front part of the chassis and a HDD cage under it. The frame for the power supply is at the back:

You don’t have to take the PSU frame out of the system case unless you want to lay the cables in the tidiest way. Let’s start with the top cage for 5.25” devices. It is held by two thumbscrews, one on each side:

When these are unfastened, the cage can be moved into the case along the rails and lifted up:

It moves on the rails using four supports:

This is a good idea, but it is not implemented well. The stiffness ribs at the top part of the case have to be released to take the cage out. On the other hand, if you often have to take the cage out of the case, you can leave it unfastened with screws. The cage will be held in place by friction.